Stainless Steel Mechanical Sand Carbon Filter for Water Treatment
Stainless Steel Filter housing Working principle:
This carbon filter consists mainly of carbon layer and supporting layers. Activated carbon has developed porosity, surface area, has the very high adsorption ability. It is by active carbon this characteristic, it is in the deep treatment who is widely used, such as drinking water, sewage hind paragraph (water) deep processing, etc.
Use active carbon adsorption after period of time, a large amount of adsorption qualitative, gradually becoming saturated, lose working ability, serious when will penetrate filter layer, and therefore should be timely regenerate active or replacement.
Supporting layer's main function is to prevent activated carbon from equipment in water erosion, when using rinse water plays a certain role uniform cloth.
The main technique parameters:
Filtration speed: 8-12m/h water turbidity: < 15mg/L
Effluent turbidity: 5mg/L working temperature: under normal temperature
Working pressure: < 0.4 Mpa filter material layer height: 1000-1200mm
Reverse-wash compressed air quantity: 18-25L/m2. S compressed air pressure: 0.1-0.2 Mpa
Reverse-wash strength: 15L/m2. S (single) 12L/m2. S (double) backwash time: 5-10 minutes
||thread or flange or TC connection
Filter technology parameters
|Filter filtration rate: 8 ~ 300m3 / h
|Backwash time: 8 to 10
|Working pressure: ≤ 0.6Mpa
|Flushing filter head loss: 0.8
|Water outlet: 2-5mg/L
|Water inlet: <10mg/L
|Water outlet: <2mg/L
|Design temperature: 5 ~ 4000C
|Single sand filter Height: 700mm (height for circulating water sand filter 500mm)
Stainless Steel Filter Housing Detail Picture